Klein Insulated Lineman's Pliers, 9-Inch (D20009NEINS)
SKU: D20009NEINS
- Pliers are individually tested to meet or exceed the ASTM F1505-16(2021) and IEC 60900:2018 standards, for insulated tools, and clearly marked with the official 1000-volt rating symbol
- Two layers of insulation provide protection against electric shock while the integral guards help prevent hand contact with conductive parts
- Thick, exceptionally tough, high-dielectric white inner coating is bonded to the tool and a flame retardant, impact-resistant, bright orange outer coating
- High-leverage design provides 46-Percent greater cutting and gripping power than other plier designs
- Made in USA
- Cuts ACSR, screws, nails, and most hardened wire
- Precision machined knives cut cleanly and crisply even on fine stranded wire, mule tape and pull line
D20009NEINS
Insulated Lineman's Pliers, 9-Inch
These Klein Tools 9-Inch Insulated Side-Cutting Pliers have jaws knurled with a cross-hatch pattern for excellent gripping. They are made of steel alloy for strength and performance. They also feature flame and impact retardant coating, as well as insulation to protect up to 1000 Volts.
Specifications
- Cut Style: Side-Cutting
- Type: Side Cutting Pliers
- Material: Induction Hardened Steel
- Sub Brand: 2000 Series®
- Application: ACSR, Screws, Nails and Most Hardened Wires
- Handle Color: Orange
- Insulated: Yes
- Handle Finish: 2-Layer Insulation
- Special Features: Integral Guards Help Prevent Hand Contact With Conductive Parts
- Joint Type: Hot-Riveted
- Standard: Yes
- Nose Type: New England
- Style: Heavy Duty Cutting
- Nominal Length: 9''
- Connector Crimping: No
- Heavy Duty: No
- Bolt Thread Holding: No
- Standards: IEC 60900 and ASTM F1505
- Fish Tape Pulling: No
- Item: Side-Cutting
- Jaw Capacity (cm): 3.6
- Jaw Capacity (Inch): 1.43
- Jaw Length (cm): 4
- Handle Length (cm): 14.6
- Knife Length (Inch): 0.781
- UPC: 092644700859
Additional Information
Warnings
- Only use tools that are marked with the official international 1000-volt rating symbol shown above, if there is any chance that the tools will make contact with an energized source.
- Whenever possible, always de-energize lines and equipment prior to working on or around them. Klein insulated tools are designed only to reduce the chance of injury where the tool may make contact with an energized source.
- Do NOT touch uninsulated portion of the tool or any conductive object when either might contact an energized source.
- Always inspect your tools before use. Destroy tool if insulation becomes damaged in any way.
- Because moisture, films, or other surface contaminants are conductive, Klein insulated tools must be kept clean, dry, and free of any surface contaminants.
| Brand | Klein Tools |